EasyManuals Logo

Lamtec F300K Series User Manual

Lamtec F300K Series
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
71
7 Operation
7.5.5 Load parameters (up load)
7.5.5.1 Load operating mode parameters (up load)
The operating mode parameters saved in the user interface for the active operating mode in
the flame scanner are reset. If you want to reset the parameters of another operating mode,
you have to activate this mode first.
NOTICE
The current settings of the flame scanner are lost.
Mode 1 selected parameters
Data that will be loaded by the user interface (UI)
Data line 1 loaded from user interface (UI)
Data line 2 received by flame scanner
The data in line 1 must match the data in line 2.
A countdown of 8 seconds begins. This is accompa-
nied by flashing. During this countdown, you have to
confirm the setting by pressing . If you do not, an
error message appears and the setting is rejected.
The transfer was successful.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lamtec F300K Series and is the answer not in the manual?

Lamtec F300K Series Specifications

General IconGeneral
BrandLamtec
ModelF300K Series
CategoryScanner
LanguageEnglish