2B-16 Developed for Training Purposes Leerjet 35/36
February 2004
CAE SimuFlite
Trim Check (FC 200 Autopilot):
PITCH TRIM Selector Switch . . . . . . . . . . . . . . . . . . . . . SEC
Pedestal NOSE DN-OFFNOSE
UP Switch . . . . . . . . . . . . . . . . . . . . . . . HOLD TO NOSE UP/
............................................................. .THEN TO NOSE DN
Check for horizontal stabilizer movement in both directions.
Stabilizer movement is at approximately one-half the rate of
PRI trim.
Either Control Wheel Trim Switch . . . . OPERATE NOSE UP/
.................................................................. THEN NOSE DN
Trim motion should not occur.
PITCH TRIM Selector Switch . . . . . . . . . . . . . . . . . . . . . OFF
ACTUATE the following:
Q
pilot and copilot control wheel trim
Q
trim arming switches
Q
pedestal NOSE DN-OFF-NOSE UP switch
Ensure that no trim motion occurs.
PITCH TRIM Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PRI
Pedestal NOSE DN-OFF-NOSE UP Switch . . . . . NOSE UP/.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . NOSE DN
Ensure trim motion does not occur.
Pilot Control Wheel Trim Switch . . . . . . . . . . . . . . .OPERATE
Without depressing arming button, move switch NOSE UP,
NOSE DN, LWD, and RWD. Check that trim motion does
not occur.
Arming Button (without displacing switch . . . . . . . DEPRESS
Ensure trim motion does not occur.
Pilot Control Wheel Trim Switch . . . . . . . . . . . . . . .OPERATE
While depressing arming button, move switch NOSE UP,
NOSE DN, LWD, and RWD. Ensure trim motion occurs in all
directions.
Copilot Control Wheel Trim Switch . . . . . . . . . . . . .OPERATE
Without depressing arming button, move switch NOSE UP,
NOSE DN, LWD, and RWD. Ensure trim motion does not
occur.