Preventive Maintenance 7-27
D-H001.0609EN
7.23 Replace the Filter Element of the Twin Filter
1. On the CRS+:
1. Press:
-
- [
ENTER].
2. Hold the filter housing and remove the cap.
3. Remove the filter housing.
4. Remove the filter sock and the spring from the filter housing.
5. Examine the filter sock for flakes that indicate mastitis in the herd.
6. Remove the filter ring and the filter sock from the spring.
7. Rinse the filter ring and the filter housing with clean water.
8. Make sure the thread and the top of the filter housing are clean and dry.
9. Slide the spring into a new filter sock and fold the sock top into the top of the spring.
10. Install the filter ring on the the spring.
11. Slide the filter sock and the spring in the filter housing until approximately 15 cm (5.90 in) of the filter sock
is outside the filter housing.
12. Hold the filter housing in position below the milkline and push the filter sock fully into the tapered part of the
milkline.
13. Connect the cap to the filter housing and tighten the cap hand-tight.
14. On the CRS+:
1. Press [
ENTER].
To Next Page
Loading...
Need help?
General
