9-4 Test and Adjustment
D-H001.0609EN
9.2.4 Adjust the Service-3 Position
1. Select:
- Tab [
Test]
- [Robot arm]
- [
Service-3].
2. In the field Set position, set the values for the X position, Y position and the Z position.
3. Select [
Move robotarm] to move the arm to the set position..
4. If the Service-3 position is not correct, do steps 2 and 3 again.
5. If the Service-3 position is correct, select [
Store arm position] to store the set values.