Operating Instructions 6-11
D-H001.0609EN
6.9.2 Change Sample Rack
On the X-Link:
1. Select Tab [
Sampling].
2. Select Change in the field Progress.
3. When the screen changes to Sample rack, Current rack number:
1. Select [
Change].
2. Type the correct value in the calculator.
3. Select [
ENTER].
4. Select [
OK].
6.9.3 Stop Sampling
1. Stop the sampling in the T4C software (refer to the T4C manual).
2. Select Tab [
Sampling].
3. Select [
Turn sampling off].
4. When the Confirm stop sampling pop-up window appears, select [
Stop] .
5. When the screen changes to Cows are not marked for sampling, Disconnect Shuttle now, when ready
press close, select [
Close] in the field Valve sampling.
6. Remove the nipple (3) and the hose (4) from the knee (1).
7. Install the plug (2) in the hole in the knee (1).
8. Remove the nipple (3) from the hose (4).
9. Remove the hose (4) from the sample unit.
10. In the field Valve sampling, select:
- [
Open]
- [
Close].
11. Make sure the tab [
Sampling] disappears.
To Next Page
Loading...
Need help?
General
