Corrective maintenance 8-3
D-H001.0609EN
20. Carefully position the mothership cover on the mothership.
21. Tighten the two bolts (3) and (4).
22. Install the screw (1) and the locking pin (4).
23. Make sure the tubes and the cables are in the correct position and install the between cover.
24. Install the locking pin (1).
25. In the field Cord cups, select:
- LF [
Fixed]
- LR [
Fixed]
- RF [
Fixed]
- RR [
Fixed]
- Tab [
System]
- [
Move to home position].
26. Put the milking robot in operation with the X-link (page 6-3).
27. Start a Short Rinse (X-link). (page 6-15)
Between Cover
To Next Page
Loading...
