LELY COSMIX P - Page 12

To Next Page

To Previous Page

INTENTIONALLY BLANK

5.2308.8512.0 B

12 PREFACE

innovators in agriculture

Main Page

Table of Contents13
Introduction (Cosmix P)17
Safety19
Signal Icons (Standard)19
Safety Instructions19
General Safety (Cosmix P)20
Electrical Safety (Cosmix P)20
Installation Safety21
Operating Safety (Cosmix P)21
Maintenance Safety (Cosmix P)21
Safety Decals22
Specifications25
Control Box (Cosmix P)25
Cow Identification Readers (Cosmix P)25
Operation Area (Cosmix P)25
External Requirements (Cosmix P)25
Description and Operation27
Introduction (Cosmix P)27
Component Description30
Frame and Fencing (Cosmix P)30
Feed Unit30
Control Box31
Cow Identification Systems38
Operator Interface (Cosmix P)39
T4C Farm Management Software39
The T4C Window Explained40
Service Interfaces40
The E-Link Manual Controller40
Menu Structure E-Link41
Cosmix Service Interface46
Operation46
Identification (Cosmix P)46
Feeding (Cosmix P)46
Installation49
Introduction (Cosmix P)49
Preparation49
List of Supplied Parts (Cosmix P)49
Preparation by the Owner50
Preparation by Lely51
Install the Cosmix P52
Preparation (Cosmix P)52
Install the Side Fences on the Portals (Cosmix P)52
Level, Square and Tighten the Fences (Cosmix P)55
Install the Portals on the Floor (Cosmix P)57
Install the Control Box58
Install the Front Plate (Cosmix P)60
Install the Feed bin and the Feed Hopper on the Front Plate63
Install the M-Box (Cosmix P)65
Install a Qwes Leg Reader and a Floor Antenna (Cosmix P)72
Connect the Cosmix P78
Connect the Air Tubes (Cosmix P)78
Connect the Qwes Reader Cable (Cosmix P)81
Connect the 230 VAC Power Supply Cable (Cosmix P)82
Prepare the Network Cable82
Install a Type 1 Network Connector (Cosmix P)82
Install a Type 2 Network Connector (Cosmix P)84
Install the Network Cable on an Earthing Clamp (Cosmix P)86
Setup the Cosmix P (Cosmix P)87
Operating Instructions89
List Details about the Rest Feed (Cosmix P)89
List a Feed Overview (Cosmix P)89
List a Device Intake Overview (Cosmix P)90
Test and Adjustment91
Connect or Remove the E-Link Manual Controller (Cosmix P)91
Set the Network Settings91
Set Defaults (Cosmix P)91
Set the Device Address of the Cosmix (Cosmix P)92
Set the T4C Device Address (Cosmix P)92
Make Basic Software Settings93
Display the Software Version (Cosmix P)93
Set the Time (Cosmix P)93
Make the Photocell Active (Cosmix P)93
Calibrate the Valves (Cosmix P)94
Set the Portion Size (Cosmix P)94
Adjust the Portion Size (Cosmix P)95
Clear All Tables (Cosmix P)95
Test the Operation of the Cosmix P95
Test the Time Setting (Cosmix P)95
Display Real Time Information (Cosmix P)96
Test the Tag-ID (Cosmix P)96
Test the Dosing Units (Cosmix P)96
Test the M-Box (Cosmix P)97
Adjust the Floor Antenna Signal (Qwes ISO Leg Models Only)97
Adjust the Detection Distance of the Photocell (Cosmix P)99
Adjustments in the T4C Software102
Add the Cosmix P to T4C (Cosmix P)102
Add a Feed Type (Cosmix P)102
Set the Feed Speed (Cosmix P)102
Adjustments with the Service Interface103
Calibrate the Valves with the Service Interface (Cosmix P)103
Troubleshooting105
Troubleshooting Table (Cosmix P)105
Troubleshooting Procedures105
Make Sure the Cow Has Feed Credit (Cosmix P)105
Make Sure the Cow Number Is Less than 32000106
Clean the Dosing Unit (Cosmix P)106
Disposal (Standard)107
Diagrams109

LELY COSMIX P - Page 12

Table of Contents

Related product manuals