5.2308.8512.0 B
5-12 INSTALLATION
7. Install the reader-bracket assembly (8) and the control box on the
bracket on the rear portal (3) with three bolts (4), washers (2) and cap
nuts (1).
8. Install the reader-bracket assembly (8) and the control box on the
bracket on the front portal (6) with two carriage bolts, washers and
cap nuts.
9. Close the cover of the control box.
Figure 22. Install the control box – Qwes LD
KEY:
1. Cap nut - 2. Washer - 3. Support bracket - 4. Carriage bolt - 5. Control box - 6. Support
bracket - 7. Earthing cable - 8. Reader-bracket assembly
5.3.6 Install the Front Plate
Parts
• 1× Front plate.
• 4× Bolt M12×80 and washer.
• 8× Nut M12.
• 2× Mounting pipe.
• 4× T-clamp.
This procedure requires a minimum of two persons.
Installation
1. Loosely install the four T-Clamps (8) (see figure 23 on page 5-14) on
the two mounting pipes (1) with an 8 mm Allen key.
innovators in agriculture
To Next Page
Loading...
