5.2308.8512.0 B
INSTALLATION 5-7
Figure 18. Lift the fences and install the rear portal
KEY:
1. Rear portal - 2. Bolt - 3. Allen bolt - 4. Allen bolt - 5. Screw driver
5.3.3 Level, square and tighten the Fences
Special tools
• Level.
Installation
1. Make sure the distance between the front and rear portal is 101.5 cm
(40.0 in), move the front portal (see figure 19 on page 5-8) if
necessary.
2. Make sure the side fences are level (2), move the T-clamps (3) up or
down if necessary.
3. Make sure the distances between the front sides of both side fences
and the opposite brackets (see figure 20 on page 5-9) are equal (A =
B).
4. Tighten the bolts and nuts on the four brackets (1) on the front portal.
5. Tighten the bolts on the four T-clamps (4) (see figure 19 on page 5-8)
with a 8 mm Allen key.
6. Remove the screwdrivers or pins from the front portal that keep the
fences in place.
innovators in agriculture
To Next Page
Loading...
