LELY COSMIX P - 7.3.1 Set Defaults; 7.3.2 Set the Device Address of the Cosmix; 7.3.3 Set the T4 C Device Address; 7.3.4 Set the IP-Adress

5.2308.8512.0 B
7-2 TEST AND ADJUSTMENT
3. Push soft button [OK] to confirm. After a few seconds you return to
the main menu.
7.3.2 Set the Device Address of the Cosmix
Block the cow traffic to the concentrate feeder before you do
this procedure.
Use the E-Link manual controller for this procedure.
1. In the main menu, select ‘NetworkSettings’ and push button [
].
2. Select ‘Dev addr Cosmix’ and push button [
].
3. Use soft buttons [<] or [>] to select the position you want to change.
4. Use buttons [
] or [ ] to change the value.
5. Push soft button [OK] to confirm. After a few seconds you return to
the main menu.
7.3.3 Set the T4C Device Address
Block the cow traffic to the concentrate feeder before you do
this procedure.
Use the E-Link manual controller for this procedure.
1. In the main menu, select ‘NetworkSettings’ and push button [
].
2. Select ‘Dev addr T4C’ and push button [
].
3. Use soft buttons [<] or [>] to select the position you want to change.
4. Use buttons [
] or [ ] to change the value.
5. Push soft button [OK] to confirm. After a few seconds you return to
the main menu.
7.3.4 Set the IP-Adress
Block the cow traffic to the concentrate feeder before you do
this procedure.
Use the E-Link manual controller for this procedure.
1. In the main menu, select ‘NetworkSettings’ and push button [
].
2. Select ‘IP Address’ and push button [
].
3. Use soft buttons [<] or [>] to select the position you want to change.
4. Use buttons [
] or [ ] to change the value.
5. Push soft button [OK] to confirm. After a few seconds you return to
the main menu.
innovators in agriculture