LELY COSMIX P - 7.4 Make Basic Software Settings

5.2308.8512.0 B
TEST AND ADJUSTMENT 7-3
7.4 Make Basic Software Settings
7.4.1 Display the Software version
Block the cow traffic to the concentrate feeder before you do
this procedure.
Use the E-Link manual controller for this procedure.
1. In the main menu, select ‘Version number’ and push button [
] .
2. Push button [
]. After a few seconds you return to the main menu.
7.4.2 Reset to the Default Settings
Block the cow traffic to the concentrate feeder before you do
this procedure.
Use the E-Link manual controller for this procedure.
1. In the main menu of the E-Link, select ‘Settings’ and push button [
].
2. Select ‘Set defaults’ and push button [
].
3. Push soft button [OK] to confirm. After a few seconds you return to
the main menu.
7.4.3 Set the Time
Block the cow traffic to the concentrate feeder before you do
this procedure.
Use the E-Link manual controller for this procedure.
1. In the main menu of the E-Link, select ‘Settings’ and push button [
].
2. Select ‘Time’ and push button [
].
3. Use soft buttons [<] or [>] to select the position you want to change.
4. Use buttons [
] or [ ] to change the value.
5. Push soft button [OK] to confirm. After a few seconds you return to
the menu ‘Settings’.
7.4.4 Make the Photocell Active
Block the cow traffic to the concentrate feeder before you do
this procedure.
Only applicable for Qwes IR readers.
innovators in agriculture