5.2308.8512.0 B
5-24 INSTALLATION
Figure 33. Install the pneumatic cylinder
KEY:
1. Nut - 2. Washer - 3. Bushings - 4. Washer - 5. Bolt - 6. Tube connector - 7. Pneumatic
cylinder - 8. Tube connector
5.3.9 Install a Qwes leg Reader and a Floor Antenna
This section only applies when you have a concentrate feeder with Qwes
leg identification.
Parts
• 1× Floor antenna mat.
• 1× EWA transformer box with pcb.
• 1× EWA transformer housing.
• 2× Bolt M8×20, washer, nut.
• 3 m (9.8 ft) coax cable.
Installation
1. Install the floor antenna mat (2) (see figure 34 on page 5-26) on the
floor, between the two piles of the front portal.
2. Make sure the coax cable (2) is fed through the hole in the upper side
of the frame (1) (see figure 35 on page 5-26) to the hole in the front
frame (1) (see figure 34 on page 5-26).
Connect the EWA transformer
innovators in agriculture
To Next Page
Loading...
