5.2308.8512.0 B
INSTALLATION 5-13
2. Install the four bolts (9) and eight nuts (7) on the mounting pipes.
The mounting pipes can be installed on three different
heights on the back plate (3) and (4)
3. Install the two mounting pipes on the rear plate with the four nuts (5)
and washers (6).
4. Remove the four bolts (3) (see figure 24 on page 5-15) from the four T-
clamps (1) with an 17 mm wrench.
Do not fully tighten the T-clamps
5. Install the front plate on the side fences with the four bolts (3).
6. Fully tighten the bolts in the T-clamp (2) with an 8 mm Allen key.
innovators in agriculture
To Next Page
Loading...
