5.2308.8512.0 B
INSTALLATION 5-11
Figure 21. Install the control box
KEY:
1. Control box - 2. Bolt - 3. Washer - 4. Nut
5.3.5.2 Install the Control box - Qwes LD Identification
Parts
• 1x Control box.
• 2x Bolt M8x13, washer and cap nut.
• 2x Carriage bolt M8x16, washer and cap nut.
• 1x Reader-bracket assembly.
Installation
1. Put the control box on the brackets (3,6) (see figure 22 on page 5-12)
between the front portal and the rear portal, with the CE plate on the
rear and the cable throughput on the front.
2. Open the cover of the control box (5).
3. Loosen the bolts (20) (see figure 40 on page 5-32) that tighten the two
strips on the cable throughput.
4. Feed the earthing cable (19), from the control box, through the cable
throughput.
5. Install a carriage bolt (4) (see figure 22 on page 5-12) through the hole
in the bottom of the control box and the strip on the front portal.
6. Install the cable shoe from the earthing cable on the carriage bolt.
innovators in agriculture
To Next Page
Loading...
