5.2308.8512.0 B
INSTALLATION 5-5
• 4× Bracket set (1.5 in×1.5 in).
• 16× Bolt, washer, nut.
• 4× T-clamps.
Installation
This procedure requires a minimum of two persons.
1. Put the front portal (1) (see figure 17 on page 5-6) on the floor, hold
it.
The front portal has a small mounting strip on top of it.
2. Loosely install both side fences (6) with the four bracket sets (5) on the
front portal with the bolts, washers and nuts.
3. Loosely install the four T-clamps (4) on the side fences with a 8 mm
Allen key (2).
4. Remove the four bolts (3) from the T-clamps.
5. Lift both side fences and put screwdrivers or pins (5) (see figure 18 on
page 5-7) in the holes in the front portals to secure the position of the
side fences.
6. Put the rear portal (1) on the floor, hold it.
Do not fully tighten the T-clamps
7. Loosely install the side fences with the T-clamps on the rear portal
with the four bolts (2).
innovators in agriculture
To Next Page
Loading...
