LELY SPLENDIMO PC 281 - 6 Dismounting from the Tractor

- First, lift the machine from the crop and then reduce
your PTO speed immediately.
The lift ram raises the cutter bar approx. 45 cm over ground
surface which is sufficient for the fast field manoeuvring.
By retracting the first part of
the ram, you can move the
mowertotheleftupto2mto
avoid obstacles in the field
(fig.15). This operation can
be carried out during work,
without having to stop.
SPLENDIMO 281 and 321
PC: this position should be
used shortly only, i.e. only to
avoid obstacles!
6 DISMOUNTING FROM THE TRACTOR
- Lower the mower conditioner onto the ground.
- Set the parking jack in the lowest position (fig. 16).
- Lower the tractor hydraulics until the parking jack rests on
the ground.
- Switch off the tractor engine. Disengage the PTO shaft
from the tractor PTO.
- Place the PTO shaft in the parking chord (fig. 16).
- Depressurize the hydraulic system and disconnect the
hydraulic hoses.
- Place the dust caps on the plugs and hook the plugs to the
support on the drawbar.
- Remove the plug for lightning from the tractor socket.
- Disconnect the lower arms from the machine.
42
15
2,3 - 2,7 m
SPLENDIMO
®
PC
16