About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read “Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1. Locate the M.2 drive slot on the system board. See
“Side view” on page 15.
Step 2. Install M.2 drive 1.
a.
Insert the M.2 drive at an angle into the connector.
b.
Place down the M.2 drive onto the screw hole.
c.
Install the screw to secure the M.2 drive in place.
Figure 76. Installing M.2 drive 1
Step 3. Install M.2 drive 2.
a.
Insert the M.2 drive at an angle into the connector.
b.
Place down the M.2 drive onto the M.2 drive retainer.
c.
Insert the retainer post into the retainer to secure the M.2 drive in place.
Chapter 5. Hardware replacement procedures 95
To Next Page
Loading...
