Lenovo ThinkSystem ST45 V3 - Install an M.2 Drive

Figure 74. Removing M.2 drive 1
Step 3. Remove M.2 drive 2.
a.
Lift the retainer post away from the M.2 drive retainer.
b.
Rotate the rear end of the M.2 drive to an angle.
c.
Remove the M.2 drive from the system board.
Figure 75. Removing M.2 drive 2
After you finish
1. Install a replacement unit. See
“Install an M.2 drive” on page 94.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install an M.2 drive
Follow instructions in this section to install an M.2 drive.
94 ThinkSystem ST45 V3 User Guide