Cable routing for bay 2 drive
Follow the instructions in this section to learn how to do cable routing for the drive in bay 2.
For the system-board connector locations, see
“System-board connectors” on page 17.
Figure 123. Cable routing for bay 2 drive
Table 9. Cable routing for bay 2 drive
From (bay 2 drive) To (system board)
Cable
1 Signal connector
1 SATA 2 connector
7pin SATA to 7pin Slim ODD SATA,
520 mm
2 Power connector
2 SATA power 1 connector
4pin power to HDD&Slim ODD, 300
mm/210 mm/120 mm
Chapter 6. Internal cable routing 149
To Next Page
Loading...
