1. Start the server and press F1 to access Setup Utility.
2. Select Security ➙ Secure Boot ➙ Secure Boot.
3. Set Secure Boot to Enabled and save the setting.
Note: If disabling UEFI Secure Boot is needed, set Secure Boot to Disabled in step 3.
Server cover replacement
Follow instructions in this section to remove and install the server cover.
Remove the server cover
Follow instructions in this section to remove the server cover.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
S014
CAUTION:
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is
authorized to remove the covers where the label is attached.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
• Read
“Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 135
To Next Page
Loading...
