Lenovo ThinkSystem ST45 V3 - Drive and Drive Cage Replacement; Simple-Swap Drive and Drive Cage Replacement (Bay 0-1)

Figure 15. CMOS battery installation
After you finish
1. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
2. Reconfigure the server and reset the system date and time.
Drive and drive cage replacement
Follow instructions in this section to remove and install a drive or a drive cage.
Note: For drive bay locations, see
“Side view” on page 15.
Simple-swap drive and drive cage replacement (bay 0-1)
Follow instructions in this section to remove and install a simple-swap drive and drive cage from and into bay
0 or bay 1.
Remove a simple-swap drive (bay 0-1)
Follow instructions in this section to remove a simple-swap drive from bay 0 or bay 1.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read
“Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 34.
• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.
Procedure
38 ThinkSystem ST45 V3 User Guide