Lenovo ThinkSystem ST45 V3 - Install the Power Button with LED

Install the power button with LED
Follow instructions in this section to install the power button with LED.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
“Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1. Install the power button with LED.
a.
Tilt the power button, and insert the tab on the bottom of the power button cable into the
slot.
b.
Push the power button into the slot until it snaps into place.
Figure 95. Installing the power button with LED
Step 2. Install the front I/O bracket.
a.
There is a small tab on the right side of the front I/O bracket. Place the tab behind the front I/
O bracket slot on the chassis.
b.
Align the guide hole and screw hole on the front I/O bracket with the guide pin and screw
slot on the chassis; then, install the front I/O bracket to the chassis. Make sure the small tab on
the right side of the front I/O bracket is placed behind the chassis.
114
ThinkSystem ST45 V3 User Guide