Figure 77. Installing M.2 drive 2
After you finish
1. If applicable, reinstall the 2.5-inch drive to bay 1. See
“Install a simple-swap drive (bay 0-1)” on page 42.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Remove the M.2 drive retainer
Follow instructions in this section to remove the retainer for M.2 drive 2.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
“Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 34.
96
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
