Step 4. If you are replacing the front or rear fan, perform the following steps.
a.
From the outside of the chassis, cut off the four rubber mounts that secure the fan to the
chassis.
b.
Slide the fan away from the chassis; then, lift it out of the chassis.
Figure 67. Removing the fan by cutting off rubber mounts
After you finish
1. Install a replacement unit. See
“Install the fan (front and rear)” on page 85.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the fan (front and rear)
Follow instructions in this section to install the front fan or rear fan.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
