CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
“Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1. Align the M.2 drive retainer with the three slots on the chassis, and lower the retainer into the
chassis; then, slide the retainer toward the 2.5-inch drive cage to secure it in place.
Figure 79. Installing the M.2 drive retainer
Step 2. Install an M.2 drive. See “Install an M.2 drive” on page 94.
After you finish
1. If applicable, reinstall the 2.5-inch drive to bay 1. See
“Install a simple-swap drive (bay 0-1)” on page 42.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Memory module replacement
Follow instructions in this section to remove and install a memory module.
98
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
