After you finish
1. If applicable, install the ODD+bay 2 drive cage assembly (see
“Install the optical drive cage” on page 80)
or install the bay 2+bay 3 drive cage assembly (see
“Install the drive cage (bay 3)” on page 69).
2. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Mono amplifier (speaker) replacement
Follow instructions in this section to remove and install the mono amplifier (speaker).
Remove the mono amplifier (speaker)
Follow instructions in this section to remove the mono amplifier (speaker).
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read “Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 34.
• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.
Procedure
Step 1. Remove the server cover. See
“Remove the server cover” on page 135.
Attention: The heat sink and processor could be very hot. To avoid burning yourself, wait for a few
minutes after turning off the server before you remove the server cover.
Step 2. Disconnect the mono amplifier cable from the system board.
Step 3. Remove the mono amplifier.
a.
Remove the screw that secures the mono amplifier to the chassis.
b.
Slide out the mono amplifier from the bracket, and remove it from the chassis.
Chapter 5. Hardware replacement procedures 105
To Next Page
Loading...
