Figure 84. Opening retaining clips
Step 3. Install the memory module into the slot.
a.
Make sure the retaining clips are in the fully open position.
b.
Align the memory module with the slot, and gently place the memory module on the slot
with both hands.
c.
Firmly press both ends of the memory module straight down into the slot until the retaining
clips snap into the locked position.
Attention: If there is a gap between the memory module and the retaining clips, the memory
module has not been correctly inserted. In this case, open the retaining clips, remove the
memory module, and then reinsert it.
Figure 85. Memory module installation
104 ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
