• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.
Procedure
Step 1. Make preparation for this task.
a. Remove the server cover. See
“Remove the server cover” on page 135.
Attention: The heat sink and processor could be very hot. To avoid burning yourself, wait for a
few minutes after turning off the server before you remove the server cover.
b. If applicable, remove the 2.5-inch drive from bay 1. See
“Remove a simple-swap drive (bay 0-
1)” on page 38
.
c. Remove M.2 drive 2. See
“Remove an M.2 drive” on page 93.
Step 2. Remove the M.2 drive retainer.
a.
Press the tab on the retainer and slightly push the nub upward.
b.
Slide the retainer forward and lift it out of the chassis.
Figure 78. Removing the M.2 drive retainer
After you finish
1. Install a replacement unit. See
“Install the M.2 drive retainer” on page 97.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the M.2 drive retainer
Follow instructions in this section to install the retainer for M.2 drive 2.
About this task
S002
Chapter 5. Hardware replacement procedures 97
To Next Page
Loading...
