Figure 87. Installing the mono amplifier
Step 2. Connect the mono amplifier cable to the system board. See
Chapter 6 “Internal cable routing” on
page 145
.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 143.
PCIe adapter replacement
Follow instructions in this section to remove and install a PCIe adapter.
Remove a PCIe adapter
Follow instructions in this section to remove a PCIe adapter.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
“Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 34.
Chapter 5. Hardware replacement procedures 107
To Next Page
Loading...
