Figure 113. Securing the front I/O bracket to the chassis
2. Install the processor. See
“Install the processor (trained technician only)” on page 124.
3. Install the heat sink and fan module. See
“Install the heat sink and fan module (trained technician only)”
on page 91
.
4. Install the memory module. See
“Install a memory module” on page 102.
5. If applicable, install the PCIe adapter. See
“Install a PCIe adapter” on page 109.
6. If applicable, install the M.2 drive. See
“Install an M.2 drive” on page 94.
7. If applicable, install the rear fan. See
“Install the fan (front and rear)” on page 85.
8. Install the cage bar. See step 3 in “Install the server cover” on page 137.
9. If applicable, install the ODD+bay 2 drive cage assembly (see
“Install the optical drive cage” on page 80)
or install the bay 2+bay 3 drive cage assembly (see
“Install the drive cage (bay 3)” on page 69).
10. Install the front bezel. See
“Install the front bezel” on page 88.
11. Reconnect all the cables that were disconnected.
12. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
13. Update the vital product data (VPD). See
https://kmp.lenovo.com/us/en/TT2403?id=2311281. Machine
type number and serial number can be found on the ID label. See
“Identify the server” on page 23.
14. Optionally, enable UEFI Secure Boot. See
“Enable UEFI Secure Boot” on page 134.
15. After replacing the system board, make sure to reconfigure the server and reset system date and time.
Enable UEFI Secure Boot
Optionally, you can enable UEFI Secure Boot.
To enable UEFI Secure Boot, do as follows:
134
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
