• Place the server on its side with the cover up.
Procedure
Step 1. Make preparation for this task.
a. Remove the server cover. See
“Remove the server cover” on page 135.
Attention: The heat sink and processor could be very hot. To avoid burning yourself, wait for a
few minutes after turning off the server before you remove the server cover.
b. Remove the front bezel. See “Remove the front bezel” on page 87.
c. Remove the front fan. See
“Remove the fan (front and rear)” on page 83.
d. If applicable, remove the M.2 drive. See
“Remove an M.2 drive” on page 93.
Step 2. Disconnect the thermal sensor cable from the system board.
Step 3. Remove the thermal sensor.
a.
Press the release tab on the thermal sensor to release it from the chassis.
b.
Remove the thermal sensor from the chassis.
Figure 118. Removing the thermal sensor
After you finish
1. Install a replacement unit. See “Install the thermal sensor” on page 141.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the thermal sensor
Follow instructions in this section to install the thermal sensor.
About this task
Chapter 5. Hardware replacement procedures 141
To Next Page
Loading...
