Lenovo ThinkSystem ST45 V3 - Simple-Swap Drive and Drive Cage Replacement (Bay 3)

Step 4. If applicable, install the 3.5-inch drive to the bay 2 drive cage. See “Install a simple-swap drive (bay
2)” on page 54
.
Step 5. Install the ODD+bay 2 drive cage assembly.
a.
Align the four pins on the sides of the optical drive cage with the four slots on the chassis
and cage bar; then, lower the drive cage assembly into the chassis.
b.
Ensure that the drive cage assembly is seated correctly; then, rotate the handle on the
optical drive cage toward the front of the chassis to secure the drive cage assembly into place.
Figure 41. Installing the ODD+bay 2 drive cage assembly
After you finish
1. If applicable, install the optical drive. See
“Install an optical drive” on page 75.
2. Connect the signal and power cables to the drive assembly. See
Chapter 6 “Internal cable routing” on
page 145
.
3. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Simple-swap drive and drive cage replacement (bay 3)
Follow instructions in this section to remove and install a simple-swap drive or drive cage from and into bay
3.
Remove a simple-swap drive (bay 3)
Follow instructions in this section to remove a simple-swap drive from bay 3.
Chapter 5. Hardware replacement procedures 61