2. Align 3 the small triangle of the processor with 4 the triangular mark on the socket.
Then, gently lower the processor evenly into the socket.
Figure 104. Installing the processor
Step 2. Close the processor retainer, and push the handle to the locked position.
Figure 105. Closing the processor retainer
After you finish
1. Install the heat sink and the fan module. See
“Install the heat sink and fan module (trained technician
only)” on page 91
.
2. If applicable, install the ODD+bay 2 drive cage assembly (see
“Install the optical drive cage” on page 80)
or install the bay 2+bay 3 drive cage assembly (see
“Install the drive cage (bay 3)” on page 69).
3. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
4. (For China only) If the message “The system detects a new processor installed or fTPM NVRAM data
mismatched.” is displayed after the server is turned on, complete the following steps to clear fTPM:
a. Back up the security data or recovery key before clearing fTPM.
b. Press F1 to start the Setup Utility program.
c. Select Security.
d. Set Reset fTPM to Enabled.
e. Restart the server.
Chapter 5. Hardware replacement procedures 125
To Next Page
Loading...
