Figure 72. Removing the heat sink and fan module
After you finish
1. Install a replacement unit. See
“Install the heat sink and fan module (trained technician only)” on page
91
.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the heat sink and fan module (trained technician only)
Follow instructions in this section to install the heat sink and fan module. The procedure must be executed
by a trained technician.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
Chapter 5. Hardware replacement procedures 91
To Next Page
Loading...
