Figure 97. Securing the front I/O bracket to the chassis
Step 3. Connect the power button cable to the system board. See
Chapter 6 “Internal cable routing” on
page 145
.
After you finish
1. Reinstall the front bezel. See “Install the front bezel” on page 88.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Power supply unit replacement
Follow instructions in this section to remove and install the power supply unit.
Remove the power supply unit
Follow instructions in this section to remove the power supply unit.
About this task
S001
116 ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
