Cable routing for bay 0 drive
Follow the instructions in this section to learn how to do cable routing for the drive in bay 0.
For the system-board connector locations, see
“System-board connectors” on page 17.
Figure 122. Cable routing for bay 0 drive
Table 8. Cable routing for bay 0 drive
From (bay 0 drive) To (system board)
Cable
1 Signal connector
1 SATA 1 connector
7pin SATA to 7pin RA SATA cable,
185 mm
2 Power connector
2 SATA power 2 connector 4pin power cable, 300 mm/80 mm
146 ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
