Cable routing for the RAID adapter and drives
Follow the instructions in this section to learn how to do cable routing for the RAID adapter and drives.
•
“Cable routing for two drives with the RAID adapter” on page 151
• “Cable routing for three drives with the RAID adapter” on page 152
For the system-board connector locations, see “System-board connectors” on page 17.
RAID adapter cable
The break lines indicate that part of the cable is hidden in the illustration.
Figure 125. Mini SAS HD X4 Vertical to VT SATA 7P x2 + RA SATA 7P x2 cable
Table 11. Mini SAS HD X4 Vertical to VT SATA 7P x2 + RA SATA 7P x2 cable
1 Connector for the RAID adapter (connector C0) 2 Connectors for the drives
Cable routing for two drives with the RAID adapter
Chapter 6. Internal cable routing 151
To Next Page
Loading...
