After you finish
1. If an M.2 drive was removed, reinstall the M.2 drive. See
“Install an M.2 drive” on page 94.
Note: The thermal sensor cable should be placed under the M.2 drive.
2. Reinstall the front fan. See
“Install the fan (front and rear)” on page 85.
3. Reinstall the front bezel. See
“Install the front bezel” on page 88.
4. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Complete the parts replacement
Go through the checklist to complete parts replacement
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Ensure that the CMOS battery is installed on the system board. See
“Install the CMOS battery (CR2032)”
on page 36
.
3. Properly route and secure the cables in the server. Refer to the cable connecting and routing information
for each component.
4. Reinstall the server cover. See
“Install the server cover” on page 137.
5. Reconnect the power cords and any cables that you removed.
Note: To avoid component damage, connect all the other cables before connecting the power cords.
6. Power on the server and any peripheral devices. See “Power on the server” on page 34.
7. Update the server configuration.
• Download and install the latest device drivers:
http://datacentersupport.lenovo.com.
• Update the system firmware. See
“Update the firmware” on page 161.
• Reconfigure the disk arrays if you have installed or removed a storage drive or a RAID adapter. See
https://pubs.lenovo.com/lxpm-overview/ for the LXPM documentation compatible with your server.
Chapter 5. Hardware replacement procedures 143
To Next Page
Loading...
