Cable routing for bay 1 drive
Follow the instructions in this section to learn how to do cable routing for the drive in bay 1.
•
“Cable routing for bay 1 drive in a configuration without bay 0 drive” on page 147
• “Cable routing for bay 1 drive in a configuration with bay 0 drive” on page 148
For the system-board connector locations, see “System-board connectors” on page 17.
Cable routing for bay 1 drive in a configuration without bay 0 drive
From (bay 1 drive) To (system board)
Cable
1 Signal connector
1 SATA 1 connector
7pin SATA to 7pin RA SATA cable,
185 mm
2 Power connector
2 SATA power 2 connector 4pin power cable, 300 mm/80 mm
Chapter 6. Internal cable routing 147
To Next Page
Loading...
