Figure 91. Installing a PCIe adapter
Step 3. Connect the PCIe adapter cables. See
Chapter 6 “Internal cable routing” on page 145.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Power button with LED replacement
Follow instructions in this section to remove and install the power button with LED.
Remove the power button with LED
Follow instructions in this section to remove the power button with LED.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Chapter 5. Hardware replacement procedures 111
To Next Page
Loading...
