Figure 52. Installing the bay 2+bay 3 drive cage assembly
After you finish
1. Connect the signal and power cables to the drive assembly. See
Chapter 6 “Internal cable routing” on
page 145
.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Optical drive and drive cage replacement
Follow instructions in this section to remove and install an optical drive and optical drive cage.
Remove an optical drive
Follow instructions in this section to remove an optical drive.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
72
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
