Figure 51. Installing the bay 3 drive cage to the bay 2 drive cage
Step 4. If applicable, install the 3.5-inch drive to the bay 3 drive cage. See
“Install a simple-swap drive (bay
3)” on page 64
.
Step 5. Install the bay 2+bay 3 drive cage assembly into the chassis.
a.
Align the four pins on the sides of the bay 3 drive cage with the four slots on the chassis and
cage bar; then, lower the drive cage assembly into the chassis.
b.
Ensure that the drive cage assembly is seated correctly; then, rotate the handle on the bay 3
drive cage toward the front of the chassis to secure the drive cage assembly into place.
Chapter 5. Hardware replacement procedures 71
To Next Page
Loading...
