Note: Installing the EMI shield is required when the original shield slot on the chassis is vacant.
a.
Insert the tabs on the left end of the EMI shield into the shield slot on the chassis.
b.
Push the EMI shield into the chassis until it snaps into place.
Figure 50. Installing the EMI shield
Step 3. Install the bay 3 drive cage to the bay 2 drive cage.
a.
Align the four hooks on the bay 3 drive cage with the corresponding hooks on the bay 2
drive cage; then, lower the bay 3 drive cage onto the bay 2 drive cage, and slide the bay 3
drive cage forward until it secures into place.
Note: Make sure the four hooks on both drive cages are fully engaged.
b.
Fasten the screw to secure the two drive cages together.
70
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
