Lenovo ThinkSystem ST45 V3 - Page 150

S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
1. Read
“Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that
you work safely.
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1. Install the thermal sensor.
a.
From the inside of the chassis, attach the end of the thermal sensor to the corresponding
slot on the front of the chassis.
b.
From the inside of the chassis, push the thermal sensor into the slot.
c.
Make sure the thermal sensor is secured in place.
Figure 119. Installing the thermal sensor
Step 2. Connect the thermal sensor cable to the system board. See Chapter 6 “Internal cable routing” on
page 145.
142
ThinkSystem ST45 V3 User Guide