b. Push the EMI shield into the chassis until it snaps into place.
Figure 39. Installing the EMI shield
Step 3. Make sure there is no optical drive installed on the optical drive cage. Then, Install the optical drive
cage to the bay 2 drive cage.
a.
Align the four hooks on the optical drive cage with the corresponding hooks on the bay 2
drive cage; then, lower the optical drive cage onto the bay 2 drive cage, and slide the optical
drive cage forward until it secures into place.
Note: Make sure the four hooks on both drive cages are fully engaged.
b.
Fasten the screw to secure the two drive cages together.
Figure 40. Installing the optical drive cage to the bay 2 drive cage
60 ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
