Step 1. Make preparation for this task.
a. Remove the server cover. See
“Remove the server cover” on page 135.
Attention: The heat sink and processor could be very hot. To avoid burning yourself, wait for a
few minutes after turning off the server before you remove the server cover.
b. Disconnect the cables from the drive assembly.
Step 2. Remove the drive assembly.
Remove the 3.5-inch drive assembly from drive bay 0
Hold the retainer handle, and lift the drive assembly out of the drive bay.
Figure 16. Removing drive assembly from drive bay 0
Remove the 2.5-inch drive assembly from drive bay 1
a.
Pinch the retainer handles.
b.
Lift the drive assembly out from the drive bay.
Chapter 5. Hardware replacement procedures 39
To Next Page
Loading...
