Figure 108. System-board screws removal sequence
Step 6. Remove the system board from the chassis.
a.
Slide the system board toward the front of the server to release the serial port connector
from the chassis.
b.
Gently grasp the system board by the edges; then, tilt the system board, and remove it from
the chassis.
Figure 109. Removing the system board from the chassis
After you finish
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Important: Before you return the system board, make sure that you install the processor socket covers
from the new system board. To replace a processor socket cover:
130
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
