Figure 135. Removing the front I/O bracket from the chassis
Step 13. Disconnect all the cables connected to the system board.
Attention: Disengage all latches, cable clips, release tabs, or locks on cable connectors
beforehand. Failing to release them before removing the cables will damage the cable connectors
on the system board. Any damage to the cable connectors may require system board replacement.
Step 14. Remove the nine screws that secure the system board in the sequence shown in the illustration
below. Keep the screws for future use.
Appendix A. Hardware disassembling for recycle 185
To Next Page
Loading...
