Lenovo ThinkSystem ST45 V3 - Page 58

Step 1. Install the bay 0 drive cage.
a.
Align the bay 0 drive cage to the slots on chassis; then, install it into the chassis. Make sure
the drive cage is seated correctly in the chassis.
b.
From the inside of the chassis, fasten the screw that secures the bay 0 drive cage to the
chassis.
c.
From the outside of the chassis, fasten the screw that secures the bay 0 drive cage to the
chassis.
Figure 28. Installing the bay 0 drive cage
Step 2. Install the front bezel.
a.
Insert the three plastic tabs on the bottom of the front bezel with the corresponding slots on
the front of the chassis.
b.
Pivot the front bezel towards the chassis until it snaps into place.
50
ThinkSystem ST45 V3 User Guide