Attention: If you are installing a 3.5-inch drive as the model in the illustration below:
Make sure the screw holes that are nearest to the drive connector are outside of the drive
retainer.
Figure 35. Drive screw hole placement on retainer
1 Screw holes nearest to the drive connector
Step 2. Install the ODD+bay 2 drive cage assembly.
a.
Align the four pins on the sides of the optical drive cage with the four slots on the chassis
and cage bar; then, lower the drive cage assembly into the chassis.
b.
Ensure that the drive cage assembly is seated correctly; then, rotate the handle on the
optical drive cage toward the front of the chassis to secure the drive cage assembly into place.
56
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
